Home > Shop/View Products > Jack Plates > Manual Jack Plates > 225 - 400 Horse Power >

JPL5500 6'' Setback Adjustable Outboard Boat Jack Plate

JPL5500 6'' Setback Adjustable Outboard Boat Jack Plate

Alternative Views:

Our Price: $274.19

Quantity in Stock:79
Availability:: Usually Ships in 24 Hours
Product Code: JPL5500

Finish Type:

Performance Plate Add-On:

Marine Silicone for Installation:

Mounting Bolts(Engine to JackPlate):

  • Single Adjusting Jack Plate
  • Made of high strength polished Aircraft Quality Aluminum
  • Bronze and Brass hardware eliminate binding
  • Adjusts easily by turning one steel bolt
  • Offers 4 inches of adjustable Vertical movement
  • 6 inches of setback
  • Weighs 35 lbs
  • 400 Maximum Horsepower
  • 1 Year Unconditional Warranty against manufacturer defects

Jack Plates are the perfect solution for long shaft engines with a short shaft transom! The engine side holes of the Jack Plate is drilled 1.500 inches higher than the transom side. Combined with the 4 inches of adjustable vertical lift you can obtain 5.500 inches at a maximum height to raise your long shaft engine and make it workable on a short shaft transom boat!

Here are the pre-drilled hole dimensions listed below in inches:

  • Pre-drilled holes for 1/2'' stainless hardware
  • 12 7/8'' across the top two holes from center to center
  • 9 7/8'' across the bottom two holes from center to center
  • 8'' of vertical distance between the top holes and bottom mounting holes

If your holes do not match this configuration, you can drill into the aluminum plate. However, by modifying the unit returns will not be accepted.

If you have any questions please feel free to email or call us, we want to help you. If we are not here or the line is busy, leave a message with your contact information and we will get back with you as soon as possible!

Average Rating: Average Rating: 4.5 of 5 4.5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 Top Notch! November 27, 2019
Reviewer: Nick Davys from Lansdale, Western Australia, Australia  
Love the quick service and quality once again, these will be a a standard part  now on our boats.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
4 of 5 Aluminum Jackplates July 29, 2019
Reviewer: SeaQuest from freeport, TX United States  
Can't give a full 5 star just yet. Just installed brackets, they look good and sturdy. We have not put the motors, or ran the vessel with them on yet, but so far so good. Thanks.

Was this review helpful to you?