Dimensions: 13'' Height, 6'' Setback, 3/8'' Thick
Total weight: 21 pounds
45 Degree Angle of Kick-Up ability
Simply
the best idea ever for the adventurous sportsman! This plate allows
access to the previously unreachable fishing or hunting ground with a
standard tiller engine without worries of prop damage.
Here's how it works:
The
jack plate is designed to swivel on the rugged stainless steel shaft in
case of an obstacle such as a stump or rock while carefully trolling
back to the hotspots your buddies can't reach!
Simply
tighten the side swivels to desired setting for your rig size and you
are protected from a potential lower unit or prop BOO-BOO! Also included
are two safety cables to prevent overtravel swiveling of engine when
an obstruction is encountered.
Tightness
is determined by engine reverse requirement. The larger the engine, the
tighter the swivels for preventing flip-up during reverse.
This
is the only Kick-Up plate manufactured by any manufacturer that has
vertical travel similar to a jack plate as well as the kick up function
in the case of hitting a log, stump or earth below.
No
springs to break and no replacement parts necessary as the JPL9638 is
made of aircraft quality aluminum and 3/8 stainless steel chain, grade
316!
Proudly manufactured and assembled
100% in the USA
CLAMP ON ENGINES:
This unit is compatible with clamp on engines by adding the accessory star-board plate. If you have a clamp-on engine that is not standard BIA Bolt pattern and wish to use this unit, in the options tab add the star-board plate for clamp on engines and it will come installed on the unit so you can use your clamps and have a solid mounting surface. The starboard plate adds 5 more pounds to the weight of the item. The plate is made from marine grade plastic that is resistant to freezing, corrosion, and rot. It is 1 inch thick and spans across the entire mounting surface so that you have plenty of room to mount your engine.
Trailer Your boat:Locking pins and similar are not necessary for your Vance Manufacturing Kick-Up unit to trailer your boat. Click
Here for more information and instructions on how to your boat with your new Vance Manufacturing Kick-Up Plate.
WARNING:
The JPL9638 Gen/3 is rated for outboard motors up to a maximum of 60
H.P. Do not encounter obstructions at speeds over 5 M.P.H and only in
the forward direction. The JPL9638 Gen/3 is not designed to encounter
obstructions while the boat is being operated in the reverse direction.
Not sure what size Bolt Kit you need to mount your Vance kick-up plate to your boat transom? Click here to use our kick-up bolt kit calculator.
Not sure what the Vance Transom Plate Inside Braces are? Click here for more info.
Vance "Kick-Up Plate" 
