Metal Lubricants & Cleaners
Jack Plate Mount Essentials
1/2'' Diameter Bolt Kits for Jack Plates (Compatible with all models except minis!)
3/8'' Diameter Bolt kits for Mini Jack Plates (JPL2410SB, JPL2412SB, JPL2710SB, JPL2712SB
Transom Plates & Mounting Templates
Drop Down Plate
Hydraulic Jack Plates
Hydraulic Kick-Up Jack Plates
Hydraulic Jack Plate Accessories
Manual Kick-Up Jack Plates
Manual Jack Plates
0 - 20 Horse Power
0 - 40 Horse Power
0 - 150 Horse Power
0 - 225 Horse Power
0 - 300 Horse Power
0 - 400 Horse Power
Why a Jack Plate & FAQ's?
Nav Menu 2
Nav Menu 3
Nav Menu 4
Nav Menu 5
Nav Menu 6
Nav Menu 7
Nav Menu 8
Drop Down Plate
DDPL6375 6'' Setback Drop Down Plate
Quantity in Stock:83
Usually Ships in 24 Hours
Clamp-On Engine Bracket Adapter:
No, I do not have a clamp-on engine and do not need.
Yes, I need the adapter plate for clamp-on engines. [Add $50.00]
Black Powder Coat [Add $50.00]
Clear Anodize [Add $80.00]
Hard Black Anodize [Add $80.00]
Raw Aluminum Finish
Marine Silicone for Installation:
10.1 Oz Tube Marine Silicone [Add $16.49]
2.8 Oz Marine Silicone [Add $10.29]
No, I don't need Marine Silicone
Mounting Bolts(Engine to JackPlate):
Add 2.5'' stainless kit [Add $11.99]
No, I do not need Mounting Bolts.
Introducing the all new Drop Down Plate! This is one of many new exciting products Vance Manufacturing has developed and released in the past year! The Drop Down plate allows the engine of your boat to be dropped down into the water instead of raised. The DDPL6375 comes in a 6'' setback and can lower your engine a total of 6 1/2'' with 3 1/2'' inches of adjustment.
You are responsible for the necessary clearance of the tilt and trim of your engine as well as steering cables or other equipment that may impair the operation of this unit.
The maximum suggested HP is 150.
Made of high strength polished Aircraft Quality Aluminum
Offers 3.500 inches of adjustable Vertical movement
6 inches of setback
Weighs 21 lbs
150 Maximum Horsepower
1 Year Unconditional Warranty against manufacturer defects
Here are the pre-drilled hole dimensions listed below in inches:
Pre-drilled holes for 1/2'' stainless hardware
12 7/8'' across the top two holes from center to center
9 7/8'' across the bottom two holes from center to center
8'' of vertical distance between the top holes and bottom mounting holes
If your holes do not match this configuration, you can drill into the aluminum plate. However, by modifying the unit returns will not be accepted.
We manufacture all of our products on our own equipment at our facility in Taft, TN!
If you have any questions please feel free to email or call us, we want to help you. If we are not here or the line is busy, leave a message with your contact information and we will get back with you as soon as possible!
Share your knowledge of this product.
Be the first to write a review »