Okay, so you're looking at purchasing a new hydraulic jack plate for your outboard engine but you're not sure what size setback you need and might not know what works best until you actually try the unit out on the water and find out what you purchased is not what you need? Vance Manufacturing has you covered, we have developed a new style of hydraulic jack plate that allows you to change the setback in about 5 minutes without having to send the unit you originally purchased back or simply have to buy a new one and keep the one you have. Our patent pending system allows for the angles attaching the hydraulic system and transom together to be unbolted and removed and exchanged with new angles that we have available and sell directly to you! If you decide to get a larger engine in the future and only have the 6 inch setback angles, no problem Vance Manufacturing has you covered and you can purchase the 8 inch angles and swap them out with the ones you currently have without having to purchase an entire new hydraulic jack plate!Overall Dimensions: 18.125'' Wide x 15.875'' Tall x Variable SetbackTransom side Dimensions: 16.125'' Wide x 12'' Tall6'' of vertical lift
Angles are 3/8'' aircraft aluminum150 HP Maximum HP Rating
Hard Black Anodized Finish Available (Salt Water Ready)Heavy Duty Solenoid Included (Winch Contactor)Includes 10 feet of wire and switch for operationEasy Installation, hydraulic pump and reservoir are self contained inside of the jackplate
Lifetime Warranty on frame against manufacturer defects1 year hydraulic pump warranty from pump manufacturerWeighs 45 pounds
Proudly machined and assembled at our own factory in TENNESSEE, U.S.A.!Patent Pending
- Jack Plates are the perfect solution for long shaft engines with a short shaft transom!
Here are the pre-drilled hole dimensions listed below in inches:
- Pre-drilled holes for 1/2'' stainless hardware
- 12 7/8'' across the top two holes from center to center
- 9 7/8'' across the bottom two holes from center to center
- 8'' of vertical distance between the top holes and bottom mounting holes
If your holes do not match this configuration, you can drill into the aluminum plate. However, by modifying the unit returns will not be accepted.
We manufacture all of our Jack Plates on our own equipment at our facility in Taft, TN!
If you have any questions please feel free to email or call us, we want to help you. If we are not here or the line is busy, leave a message with your contact information and we will get back with you as soon as possible!
Not sure what size Bolt Kit you need to mount your Vance hydraulic jack plate to your boat transom? Click here to use our hydraulic jack plate bolt kit calculator.
Not sure what the Vance Transom Plate Inside Braces are? Click here for more info.
Not sure which Vance Coating option to choose? Click here for more info.
6, 8. & 10 inch Setback
0 - 150 HP Engines.